Mitsubishi automatic transmission adaptation stages:

1. Preparation:

* Warm up the car to operating temperature.
* Set the gear shift lever to “P” position.
*Connect the OBD-II scanner to the car.

2. Clearing automatic transmission memory:

* Run the scanner and select the automatic transmission control module.
* Reset the automatic transmission memory in the “Service” or “Special functions” section.

3. Adaptation procedure:

* Start the adaptation procedure in the scanner.
*Follow the instructions on the scanner, which may include the following steps:

* Switch between modes “D” (drive), “N” (neutral) and “R” (reverse).
* Acceleration within a certain speed range.
* Braking to a complete stop.

4. Completion:

* Once the onboarding procedure is complete, the scanner will usually display a success message.
* Turn off the ignition and wait a few minutes before starting the engine again.

Additional tips:

* Before adapting the automatic transmission, it is recommended to replace the transmission fluid and filter.
* Use high-quality transmission fluid recommended in the vehicle’s owner’s manual.
* If you do not have an OBD-II scanner, you can contact your dealer or car service center to perform automatic transmission adaptation.
* Automatic transmission adaptation can improve gear shifting, reduce jerking and improve fuel economy.

Note: The adaptation steps may vary depending on the Mitsubishi vehicle model. Be sure to check your vehicle’s owner’s manual or consult with a vehicle service professional.

Thanks for reading!